This post is about how to clean front load washing machine.
This post may contain affiliate links, please see our disclaimer for details.

If you've been dreading the long awaited wash machine cleaning, now is the time! If you aren't sure how to clean front load washing machine, we shared a step-by-step guide for you to copy!
We also made sure to include the must have materials to properly clean your wash machine. There are also several maintenance tips that will help your wash machine in the long run!
This post is about how to clean front load washing machine.
Materials Needed:
Step-By-Step: How To Clean Front Load Washing Machine
Step One: Drain Washer
Drain by removing the cap from the hose only. Have a big bowl or cup ready to keep draining it until it stops. I also put a towel under the washer during this process. After it stops, I unscrew the white filter, dry it completely, and then spay it with antibacterial spray.
Step Two: Remove Detergent Drawer

Once you remove the detergent drawer, begin washing it. You can bleach it or just use soap. If it's moldy make sure to use bleach. You can soak it in soap, but don't soak it in bleach. Spray out the empty area when the drawer is removed with antibacterial spray.
Step Three: Clean Out Seal

Pull back silicone seal/edge & remove any hair. Spray with antibacterial.
Step Four: Cleaning Tablets

Run a cleaning tablet on your washers cleaner cycle & then wipe the drum out after.
Looking for other cleaning guides?
Maintenance Tips For Washing Machine
Mind Your Detergent
- Use only the recommended amount. Too much soap leads to residue and odor.
- Make sure you’re using high-efficiency (HE) detergent if your washer requires it.
Keep It Dry
- Leave the door or lid open after each load to let the drum air out.
- Wipe the gasket, drum, and detergent drawer to prevent mildew from forming.
Don’t Forget the Details
- A quick wipe-down after each use keeps grime from building up.
- Clean the rubber seal, lint trap, and detergent dispenser regularly.

Run a Monthly Maintenance Cycle
- Once a month, run an empty hot cycle with vinegar or a washer cleaner tablet.
- This helps dissolve detergent buildup and keeps your machine smelling fresh.
Check Hoses and Filters
- Inspect hoses every few months for cracks or leaks.
- Rinse the inlet filter to keep water flowing properly.
Avoid Overloading
- Fill the drum only about three-quarters full so clothes can move freely.
- Overstuffing causes strain on the motor and leaves residue behind.

Use the Right Settings
- Run a hot water cycle occasionally to kill bacteria and dissolve detergent.
- Use gentle or quick cycles for smaller loads to save energy and reduce wear.
Freshen Between Deep Cleans
- Sprinkle baking soda in the drum or run a quick vinegar rinse to neutralize odors.
Keep the Laundry Area Clean
- Make sure the area stays dry and well-ventilated to prevent mold.
- Wipe the exterior of the washer and clean around and underneath it.
Leave a Reply